| 1. |
Do not allow children to play with fixed controls. Keep remote
controls away from children. |
| 2. |
Frequently examine the installation for imbalance and signs
of wear or damage to cables and springs, if applicable. Do
not use if repair or adjustment is necessary. |
| 3. |
Watch
the moving shutter and keep people away until the shutter
is completely closed. |
| 4. |
Take care when operating the manual release with the shutter
open since it may fall rapidly due to weak or broken springs.
|
| 5. |
This
drive must be installed at a height of more than 2.5m above
the floor or other level that could give access to it. |
| 6. |
The instructions shall state that the actuating member for
manual release is to be installed at a height more than 1.8m.
( for model 200RS60-8R ) |
| 7. |
After installing the drive, remove any unnecessary cords and
any disabled equipment not needed for powered operation.
|
| 8. |
If the supplied cord is damaged, it must be replaced by the
manufacturer or its service agent or a similar quality person
in order to avoid a hazard. |
| 9. |
A disconnection device from the supply having a contact separation
of at least 3 mm in all poles, must be incorporated in the
fixed wiring. |
| 10. |
Installation and wiring must be in compliance with your local
building and electrician codes.
Contact a qualified electrician or TESC engineer. |